Claw retipping & re-clawing

First tip from £50 · inspected at the bench

Worn claws are the most common way a stone is lost. The small claws that hold it wear thin over the years, and once they are too thin to grip, the stone is one knock away from gone.

Retipping claws on rings is some of the most common work at our bench. We build worn tips back up, or replace the claws where they are too far gone, matching the metal and the style of the original setting. Bring it in and a goldsmith will look at it under magnification, free of charge.

Eve at the laser welder in the Diss workshop, looking through its microscope with both hands inside the chamber
Eve at the laser welder in Diss.

Why ring claws wear down

Every claw wears in the end. How fast depends on the metal, how the ring is worn and what it is worn next to. The carat of the metal decides how hard or soft it is, and softer metal gives way sooner. A ring worn every day loses more than one kept for occasions. And two rings worn together wear each other out: an engagement ring and a wedding band rub against each other with every movement of the hand.

Retipping or a full re-claw?

There are three ways to put a worn claw right. We will show you which one yours needs before any work starts.

Where the claw is still sound at the base, we build the tip back up. The laser welder lets us add metal a little at a time until the claw is back to its shape. This is the smaller job, and the one to catch early.

Before retipping: a diamond solitaire seen from above, its claw tips worn down to the edge of the stone
Before. The tips worn down to the edge of the stone.
The same diamond solitaire from above after retipping, each claw tip built back up over the stone
After. Lyn built each tip back up.
Side view of the yellow gold solitaire before retipping, held between finger and thumb at the bench
Before, from the side.
Side view of the same solitaire after retipping, held in tweezers, the white gold head with its rebuilt claws
After, from the side.

Where a claw is too far gone, we attach a new one in its place.

Where the whole setting has worn, as it often has on an older ring, we drill out the old claws and fit a new set. That is closer to a restoration. It takes longer and costs more.

Before re-clawing: an old-cut diamond solitaire in a yellow gold ring, held against the bench peg, its claws worn flat to the stone
Before. The claws had worn flat to the stone.
The same diamond ring after re-clawing, held at the bench peg, with a new set of double claws gripping the stone
After. Paul fitted a new set of double claws.
Close view of the re-clawed ring between finger and thumb, showing the new double claws around the old-cut diamond
The new claws, ready to polish.

Does the stone have to come out?

Often not. The laser welder keeps its heat to the claw, so depending on the stone we can rebuild the claws with it still set, without unmounting and resetting it. Some stones do not take well to heat. If yours is one of them, and especially if it is valuable, we may take it out before we work on the ring and set it again afterwards. We will tell you which applies before we start.

Every repair is quality-checked and polished before it comes back to you.

Common questions about claw retipping

Ask us at the bench

How do I know if my claws need retipping?

If a stone moves or catches on fabric, or the claw tips look flat or thin, it’s time. Bring it in and we’ll check it under magnification and quote while you are here.

How much does claw retipping cost?

The first retipped claw starts at £50: a £25 starting charge plus £25 for the tip. Further tips, new claws and a full re-claw are priced according to the setting. We quote before work begins.

Will it damage the stone?

We work so that it doesn’t. The laser welder keeps the heat to the claw, and where a stone does not take well to heat we remove it first and set it again once the claws are rebuilt.

How often should claws be checked?

Once a year is a good habit. If the claws are already very worn, have them checked more often, and think about not wearing the ring until they are repaired: if a claw fails, the stone can be lost.

How long does it take?

Repairs take two weeks.

Let us check the setting

Bring the piece in for a quote and a closer look at the claws. Repair work takes two weeks.

1 Market Place, Diss, Norfolk IP22 4JT
01379 644790

Sending a repair by post? See how it works

Thank you, your enquiry is on its way. We’ll be in touch, usually within two working days (Mon–Sat). For anything urgent, call 01379 644790.